NCR 7167 - Vertical Positioning and Print; Horizontal Positioning Commands

7167 Owner’s Manual Chapter 6: Commands
November 2003
90
Vertical Positioning and Print
Hexadecimal Command
Code and Operands
Command Name Page
0A Print and Feed Paper One Line 117
0C Print and Return to Standard Mode/Print and
Eject Slip
117
0D Print and Carriage Return 118
14 n Feed n Print Lines 118
15 n Feed n Dot Rows 119
16 n Add n Extra Dot Rows 119
17 Print 120
1B 32 Set Line Spacing to 1/6 Inch 121
1B 33 n Set Line Spacing 121
1B 4A n Print and Feed Paper 122
1B 4B n Print and Reverse Feed Paper 123
1B 64 n Print and Feed n Lines 124
1B 65 n Print and Reverse Feed n Lines 123
1D 14 n Reverse Feed n Lines 124
1D 15 n Reverse Feed n Dots 124
1D 50 x y Set Horizontal and Vertical Minimum Motion
Units
125
Horizontal Positioning Commands
Hexadecimal Command
Code and Operands
Command Page
09 Horizontal Tab 126
1B 14 n Set Column 126
1B 24 n1 n2 Set Absolute Starting Position 127
1B 44 [n] k 00 Set Horizontal Tabs 128
1B 5C n1 n2 Set Relative Print Position 129
1B 61 n Select Justification 130
1D 4C nL nH Set Left Margin 131
1D 57 nL nH Set Printing Area Width 132