7167 Owner’s Manual Chapter 3: Solving Problems
November 2003
11
Using the Printer
Note: See “Setting Switches” earlier in this book for instructions on setting the DIP switches.
1. Connect the power supply cable to the printer and turn on the power source.
The printer goes through a self-test routine to ensure everything is working properly then
“beeps.” After the printer has completed its “startup” cycle, it is ready to receive data.
If the LED blinks, or the host computer indicates that there is a problem, see “Chapter 3: Solving
Problems” for more information.
2. To perform a Configuration check (optional), reset the printer while holding the Paper Feed
Button, or open the receipt door and while pressing the paper feed button close the receipt door,
let go of the Paper Feed Button once the printing begins.
Note: The printer receives power when the power supply is on even if the printer is off-line. To
completely remove power, unplug the power supply from the outlet, or turn the POS terminal off.
LED
Paper Feed
Button
To Next Page
Loading...
