7167 Owner’s Manual Chapter 4: Diagnostics
November 2003
67
Receipt Synchronization Mode
The standard mode for synchronization allows for verification of each line printed to the
host. When the receipt synchronization is disabled the printer will allow for maximum
print speed and ignore the verificaiton of each line printed.
Press the Paper Feed Button for the receipt synchronization mode option you want.
** SET RECEIPT SYNCHRONIZATON MODE ?
YES -> Long Click
NO -> Short Click
Enable Receipt Sync.* -> Long Click
Disable Receipt Sync. ->Short Click
Note: Press the Paper Feed Button for at least one second to validate the selection.
Platen Waiting Time
This function makes it possible for the user to select whether to select wait time which
paper detect from . (See “Configuring the Printer” for instructions on how to enter the
Configuration Menu to change this setting.)
Press the Paper Feed Button for the platen waiting time option you want.
** SET PLATEN WAITING TIME ?
YES -> Long Click
NO -> Short Click
No Extra Time* -> 1 Click
Extra 1 sec -> 2 Clicks
Extra 2 sec -> 3 Clicks
Save Parameters
This function allows to save the selected emulations/software settings or return to the
emulations/software settings to select additional options.
Press the Paper Feed Button for the option you want.
Save new parameters ?
YES -> Long Click
NO, MODIFY -> Short Click
Hardware Options
Print Density
This function makes it possible to adjust the energy level of the print head to darken the
printout. An adjustment should only be made when necessary. The factory setting is 100%.
Warning: Choose an energy level no higher than necessary to achieve a dark printout.
Failure to observe this rule may result in a printer service call or voiding of the printer
warranty. Consult your NCR technical support specialist if you have any questions.
To Next Page
Loading...
