7167 Owner’s Manual Chapter 4: Diagnostics
November 2003
66
** SET CARRIAGE RETURN USAGE ?
YES -> Long Click
NO -> Short Click
Ignore CR -> Long Click
Use CR as Print Cmd* -> Short Click
Note: Press the Paper Feed Button for at least one second to validate the selection.
Asian Mode
*
This function makes it possible for the user to select an Asian character for the printer. (See
“Configuring the Printer” for instructions on how to enter the Configuration Menu to
change this setting.)
Note: For Asian code pages, only one (either 932, 936, 949 or 950)will exist in the
firmware.
Press the Paper Feed Button for the Asian mode you want.
** SET ASIAN MODE ?
YES -> Long Click
NO -> Short Click
Asian Mode On -> Long Click
Asian Mode Off* -> Short Click
Note: Press the Paper Feed Button for at least one second to validate the selection.
Slip Printing Width
This function allows for the 7167 printer to be set in a mode that allows for the printer to
drop the left 21 columns of data. For example if the printer was connected to an
application that was sending data for a 7158 printer which supports 66 columns of print
the 7167 printer could replace the 7158 without application changes.
Press the Paper Feed Button for the slip printing width option you want.
** SET SLIP PRINTING WIDTH ?
YES -> Long Click
NO -> Short Click
7167 MODE* -> Long Click
7158/7156 MODE -> Short Click
Note: Press the Paper Feed Button for at least one second to validate the selection.
*
Not supported by 7167-1035 and 7167-2035
To Next Page
Loading...
