NCR 7167 - User Data Storage Commands; Asian Character Commands

7167 Owner’s Manual Chapter 6: Commands
November 2003
96
Check Flip Command
Hexadecimal Command
Code and Operands
Command Page
1B 77 46 Check Flip Command 212
User Data Storage Commands
Hexadecimal Command
Code and Operands
Command Page
1B 27 m addr d1…dm Write to User Data Storage 212
1B 34 m addr Read from User Data Storage 213
1B 6A k Read from Non-Volatile Memory 214
1B 73 n1 n2 k Write to Non-Volatile Memory (NVRAM) 214
1D 22 n Select Memory Type (SRAM/Flash) Where to
Save Logos or User-Defined Fonts
215
1D 22 55 n1 n2 Flash Allocation 216
1D 40 n Erase User Flash Sector 217
IF 11 [m n],[m n]…[m
n] 0FFH
Printer Setting Change
218
Asian Character Commands
Hexadecimal Command
Code and Operands
Command Page
1C 21 n Select print modes for Kanji characters 221
1C 2D n Turn underline mode ON/OFF for Kanji
222
1C 32 c1 c2
d1…dn
Define user-defined Kanji characters
222
1C 53 n1 n2 Set Kanji character spacing
223
1c 57 n Set quadruple mode ON/OFF for Kanji
224