NCR 7167 - Slip Station

7167 Owner’s Manual Appendix B: Print Characteristics
Novembery 2003 262
Slip Station
The slip station prints characters (standard pitch and compressed pitch) and graphics in a
print zone of 82.2 mm (3.24 inches) wide on a slip or form.
Standard pitch: 45 characters (columns) per line
Compressed pitch: 55 characters (columns) per line
Double byte character: 27 characters (columns) per line
The print line height of 10 half dot x 7 dot characters is 2.46 mm (.097 in). With three-dot
spacing, the print line height is 3.53 mm (.139 inches). See the following illustration (not to
scale). To print as close to the bottom of the slip as possible without the slip leaving the
feed rollers, use the Print and Feed n Lines (1B 64 n), with n = 0.
Top Margin, 16.8 mm (.69 in.)
Minimum
Print Zone, 53.05 mm (2.09 in.)
424 Dots
Left and Right Margins, 4.00 mm (.10 in.)
Paper Width = 58 mm (2.28 inc.)
Paper Width: Not Restricted
Top Margin, 16 mm (.63 in.) Minimum
(Without Reverse Feed)
No Top Margin with Reverse Feed
Print Zone, 82.2 mm (3.24 in.)
Left and Right Margins, 3.2 mm (.125 in.)
Bottom Margin: 15.0 mm (.59 in.)