7167 Owner’s Manual Chapter 5: Communication
November 2003
81
Switch Settings
The DIP switches are located on the PC board at the back of the printer as shown in the
illustration in “Level 1 Diagnostics” in chapter 4. The switches are used to put the printer
into various modes for printer configuration set up.
Use a paper clip or other pointed object to set the switches.
1. Set the switches to the desired settings shown in the table.
2. Reset the printer.
Caution: Setting switch 1 to On puts the printer in level 1 diagnostics (setup mode) where
other functions and tests can be changed.
DIP Switch Settings for RS-232C Parameters
Switch 1
Setting
Switch 2 Setting Printer State
OFF (0) OFF (0)
On-line Mode (default)
ON(1) OFF (0)
Diagnostic Mode
OFF (0) ON (1)
Flash Download Mode
ON (1) ON (1)
Vendor Adjustment Mode
Setting Extra RS-232C Options
The following extra options are available for the RS-232C Interface:
Data errors
• Print “?” for data errors (default)
• Ignore data errors
To Next Page
Loading...
