7167 Owner’s Manual Chapter 4: Diagnostics
November 2003
61
MICR Test mode -> 1 Click
Check Flip Test mode -> 2 Clicks
Print Head Test Mode -> 3 Clicks
Enter code, then hold Button DOWN
At least 1 second to validate
Datascope Mode
Datascope Mode allows the user to test the printer’s communications. When in Datascope
Mode the printer receives all communications, but instead of executing the commands it
prints them out on receipt paper as hexadecimal numbers in the order received. For
example, the ASCII character “A” is printed as the hexadecimal number 41 an so on.
To run the Datascope Mode:
1. Enter the Configuration Menu. See “Configuring the Printer” for instruction on how to
enter the Configuration Menu.
2. After you have enabled the Datascope Mode through the Configuration Menu, exit the
Configuration Menu.
3. Run a transaction from the host computer.
All commands and data sent from the host computer will be printed as hexadecimal
numbers as shown in the illustration.
30 31 32 33 34 35 36 37 38 39 40 41 : 0 1 2 3 4 5 6 7 8 9 @ A
41 42 43 44 45 46 47 48 49 50 51 52 : A B C D E F G H I J K L
To exit the Datascope Mode:
1. Enter the Configuration Menu again
2. Disable the Datascope Mode
3. Exit the Configuration Menu
The printer is in Normal Mode and can communicate with the host computer.
Slip Test Mode
To run the Slip Test Mode:
1. Enable the Slip Test Mode through the Configuration Menu, (See “Configuring the
Printer,” for instructions on how to enter Configuration Menu). Then exit the
Configuration Menu.
2. Insert a slip into the slip station.
3. Push the Paper Feed Button
4. All code pages will be printed.
5. Go to step 2 again to repeat this test.
To exit the Slip Test Mode:
1. Enter the Configuration Menu again.
2. Disable the Slip Test Mode.
To Next Page
Loading...
