NCR 7167 - Page 233

7167 Owner’s Manual Chapter 6: Commands
November 2003
220
m
(Hex)
Function n
(Hex)
Function
38 MICR dual pass option
00
01
Dual pass disable
Dual pass enable
40 Default Code page 00
01
02
03
04
05
06
07
08
09
0A
0B
0C
0D
437
850
852
858
860
862
863
864
865
866
874
1252
Katakana
932 (or 936, 949, 950)
1
50 EEPROM default setting 00 EEPROM default setting
Set the printer configuration specified by m and n. The printer is reset after receiving this
command to activate the configuration setting. If m or n is out of range, this command is
ignored. The printer will wait for the data until the terminator code “0FFH” is received.
Example:
The following command would set the communication baud rate to 115,200 bps.
MSComm1.Output = Chr$(&H1F) & Chr$(&H11) & Chr$(&H11) & Chr$(&H0) & Chr$(&HFF)
1
Not supported by 7167-1035 and 7167-2035