NCR 7197 - Page 126

Chapter 6: Commands 7197 Owner’s Guide
February 2002
108
Turns double strike mode on or off. Identical to Emphasized mode command. The printer
is reset to the standard print mode after a line has been printed or after a Clear Printer
(0x10) command is received.
Example:
• MSComm1.Output = Chr$(&H1B) & Chr$(&H47) & Chr$(n)
Exceptions:
These settings do not apply in Page Mode. However they can be set or cleared in Page
Mode.
Double-strike printing cannot be used with bit-images or downloaded bit-images.
Related Information:
This command and the Select Print Mode(s) comand (1B 21) functionidentically. They
should have the same setting when used together.
In 7193 Emulation, this command is unrecognized and the parameter byte is put in to the
printer buffer.
Select or Cancel Italic Print
ASCII: ESC I n
Hexadecimal: 1B 49 n
Decimal:
27 73 n
Value of n:
0 = Off
1 = On
(When 0 and 1 are the Least Significant Bit, LSB)
Default:
0 (Off)
Turns Italic print mode on or off. This command is only available in 7194 Native Mode
and 7197 Native Mode. Italic print mode is available for built-in, user-defined characters.
Example:
• MSComm1.Output = Chr$(&H1B) & Chr$(&H49) & Chr$(n)
Exceptions:
Only the lowest bit of n is valid. This command is only valid for the receipt station in 7194
Native Mode and 7197 Native Mode.