Chapter 5: Communications 7197 Owner’s Guide
February 2002
66
Switch Settings
The DIP switches are located on the PC board at the back of the printer as shown in the
illustration in “Level 1 Diagnostics” in chapter 4.
The switches are used to put the printer into various modes for printer configuration set
up.
Use a paper clip or other pointed object to set the switches.
1. Set the switches to the desired settings shown in the table.
Caution: Do not set switch 1 to On. Setting switch 1 to On puts the printer in level 1
diagnostics (setup mode) where other functions and tests can be changed.
DIP Switch Settings
Switch 1
Setting
Switch 2 Setting Printer State
OFF (0) OFF (0)
On-line Mode (default)
ON(1) OFF (0)
Diagnostic Mode
OFF (0) ON (1)*
Flash Download Mode
ON (1) ON (1)
Vendor Adjustment Mode
* It is optional to set this switch to ON when reflashing the IPL firmware.
Printer End View
To Next Page
Loading...
