7197 Owner’s Manual Chapter 2: Setting Up and Using the Printer
37 November 2002
Loading and Changing the Receipt Paper
Although the illustrations show a used roll being removed, the instructions apply to
loading paper for the first time.
Change the paper when either of the following two conditions occurs:
• LED blinks (slow): the paper is low
There are approximately 1 ½ to 7 ½ meters (5-25 feet) of paper remaining on the roll.
Change the paper as soon as possible to avoid running out part way through a
transaction.
Depending on the application program, the host computer may alert you when the
paper is low.
• LED blinks (fast): the paper is out
Change the paper immediately or data may be lost.
Caution: Do not operate the printer or host computer if the printer runs out of paper.
The printer will not operate without paper, but it may continue to accept data from the
host computer. Because the printer cannot print any transactions, the data may be lost.
Removing the Paper Roll
1. Open the receipt cover.
2. Remove the used roll.
To Next Page
Loading...
Need help?
General
