NCR 7197 User Manual

Chapter 6: Commands 7197 Owner’s Guide
February 2002
76
User Data Storage Commands
Code (Hexadecimal) Command Page
1B 27 m addr d1…dm Write to User Data Storage 162
1B 34 m addr Read from User Data Storage 162
1B 6A k Read from Non-Volatile Memory
163
1B 73 n1 n2 k Write to Non-Volatile Memory (NVRAM)
163
1D 22 n Select Memory Type (SRAM/Flash) Where to
Save Logos or User-Defined Fonts
164
1D 22 55 n1 n2 Flash Allocation 165
1D 40 n Erase User Flash Sector 166
IF 11 [m n],[m n]…[m
n] 0FFH
Printer Setting Change
167
Asian Character Commands
Code (Hexadecimal) Command Page
1C 21 n Select print modes for Kanji characters
170
1C 2D n Turn underline mode ON/OFF for Kanji
171
1C 32 c1 c2
d1…dn
Define user-defined Kanji characters
171
1C 53 n1 n2 Set Kanji character spacing
172
1c 57 n Set quadruple mode ON/OFF for Kanji
173
Flash Download Commands
Code (Hexadecimal) Command Page
1B 5B 7D Switch to Flash Download Mode
174
1D 00 Request Printer ID 174
1D 01 Return Segment Number Status of Flash Memory 175
1D 02 n Select Flash Memory Sector to Download 175
1D 06 Get Firmware CRC 176
1D 07 Return Microprocessor CRC 176
1D 0E Erase the Flash Memory 177
1D 0F Return Main Program Flash CRC 177
1D 10 n Erase Selected Flash Sector 178
1D 11 aL aH cL cH
d1…dn
Download to Active Flash Sector 179
1D FF Reboot the Printer 180

NCR 7197 Specifications

General

Paper Width	80 mm
Connectivity	Serial
Print Technology	Thermal
Interface	RS-232
Resolution	203 x 203 dpi