NCR 7197 - Horizontal Positioning Commands

7197 Owner’s Guide Chapter 6: Commands
November 2002
73
Horizontal Positioning Commands
Code (Hexadecimal) Command Page
09 Horizontal Tab 92
1B 14 n Set Column 92
1B 24 n1 n2 Set Absolute Starting Position 93
1B 44 [n] k 00 Set Horizontal Tabs 94
1B 5C n1 n2 Set Relative Print Position 95
1B 61 n Select Justification 96
1D 4C nL nH Set Left Margin 97
1D 57 nL nH Set Printing Area Width 98
Print Characteristic Commands
Code (Hexadecimal) Command Page
12 Select Double-Wide Characters 100
13 Select Single-Wide Characters 100
1B 12 Select 90 Degree Counter-Clockwise Rotated Print 100
1B 16 n Select Pitch (Column Width) 101
1B 20 n Set Character Right-Side Spacing 102
1B 21 n Select Print Modes 103
1B 25 n Select or Cancel User-Defined Character Set 104
1B 26 s c1 c2 d1…dn Define User-Defined Characters 104
1B 2D n Select or Cancel Underline Mode 105
1B 3A 30 30 30 Copy Character Set from ROM to RAM 106
1B 3F n Cancel User-Defined Characters 106
1B 45 n Select or Cancel Emphasized Mode 107
1B 47 n Select Double Strike 107
1B 49 n Select or Cancel Italic Print 108
1B 52 n Select International Character Set 109
1B 56 n Select or Cancel 90 Degrees Clockwise Rotated
Print
110
1B 72 n Select Print Color
110
1B 74 n Select International Character Set 109
1B 7B n Select or Cancel Upside Down Printing Mode 110
1D 21 n Select Character Size 111