Chapter 4: Diagnostics 7197 Owner’s Guide
DFebruary 2002
56
Hardware Options
Print Density
This function makes it possible to adjust the energy level of the print headto darken the
printout. An adjustment should only be made when necessary. The factory setting is 100%.
Warning: Choose an energy level no higher than necessary to achieve a dark printout.
Failure to observe this rule may result in a printer service call or voiding of the printer
warranty. Consult your NCR technical support specialist if you have any questions.
Press the Paper Feed Button for the print density you want.
** SET PRINT DENSITY ?
YES -> Long Click
NO -> Short Click
100 %* -> 1 Click
110 % -> 2 Clicks
120 % -> 3 Clicks
Enter code, then hold Button DOWN
At least 1 second to validate
Note: Press the Paper Feed Button for at least one second to validate the selection.
Maximum Power Option
This function allows the user to set the maximum power for the printer to 75W or 55W.
Press the Paper Feed Button for the option you want.
** SET MAX POWER OPTION ?
YES -> Long Click
NO -> Short Click
55W Power Supply* -> Long Click
75W Power Supply -> Short Click
Note: Press the Paper Feed Button for at least one second to validate the selection.
To Next Page
Loading...
Need help?
General
