Chapter 2: Setting Up and Using the Printer 7197 Owner’s Guide
February 2002
18
4. Reset the printer. See below for information on resetting the printer.
The printer beeps, prints the current configuration, then waits for you to make a
selection from the Main Menu on the printout.
DIP Switch Settings Information
Switch 1 Settings Switch 2 Settings Printer State
OFF (0) OFF (0) On-line Mode (default)
ON (1) OFF (0)
Diagnostic Mode
OFF (0) ON (1)
Flash Download Mode
ON (1) ON (1)
Vendor Adjustment
Mode
Back of Printe
Bottom
Cover
Switch 2 is shown in
the OFF
ositio
To Next Page
Loading...
