NCR 7197 - Page 280

Index 7197 Owner’s Guide
February 2002
262
commands, 126
Printer status commands, 126
Printhead
thermal, 3
Printhead, thermal
cleaning, 6
over/under temperature, 41
Printing, continuous
limitations of, 201
Problems, 39
contacting a service representative, 42
knife failure, 40
paper jam, 40
paper out, 40
print is light or spotty, 41
printhead over/under temperature, 41
Protocol, RS-232C
DTR/DSR, 63
XON/XOFF, 63
—R—
Real time
commands, 137
Real time commands, 137
alternate implementation, 137
preferred implementation, 137
using, 137
Receipt station
character dot patterns, 203
print zones, 204
Receipt test modes
setting, 52
Reliability, 201
Repacking printer, 10
Reset, 13
Rotated printing
summary, 115
RS 232 interface
setting, 49
RS 232 interface settings, 49
RS-232C interface, 62
cash drawer connector, 65
communication connector, 64
DTR/DSR protocol, 63
parameters, 66
setting extra options, 67
technical specifications, 63
XON/XOFF protocol, 63
—S—
Setting switches, 12
RS-232C parameters, 66
Setup mode. See Level 1 diagnostics
Specifications, 199
RS-232C interface, 63
Speed, 62
Supplies
cash drawer, 5
communication cables, 5
paper, 4
power cord, 5
power supply, 5
shipped separately, 8
Switch settings, 12
Switch Settings
RS-232C parameters, 66
—T—
Technical specifications
RS-232C interface, 63
Thermal paper
ordering, 4
requirements, 4
suppliers, 4
Thermal printhead. See Printhead
cleaning, 6
print density, 201
Timing, 62
Troubleshooting. See Problems
Turning on the printer, 36
—U—
User data storage
commands, 162
User data storage commands, 162
Using real time commands, 137
—V—
Vertical Positioning Commands, 86
—W—
Weight, of printer, 201
—X—
XON/XOFF protocol, 63