NCR 7197 - Page 87

7197 Owner’s Guide Chapter 6: Commands
November 2002
69
Code (Hexadecimal) Command Page
1B 2D n
Select or Cancel Underline Mode 105
1B 2E m n rl rh d1…dn Print Advanced Raster Graphics 119
1B 32 Set Line Spacing to 1/6 Inch 89
1B 33 n Set Line Spacing 89
1B 34 m a0 a1 a2 Read from User Data Storage 162
1B 3A 30 30 30 Copy Character Set from ROM to RAM 106
1B 3F n Cancel User-defined Characters 106
1B 40 Initialize Printer 82
1B 44 [n] k 00 Set Horizontal Tabs 94
1B 45 n Select or Cancel Emphasized Mode 107
1B 47 Select Double Strike (7193 Emulation) 107
1B 49 n Set or Cancel Italic Print 108
1B 4A n Print and Feed Paper 90
1B 4C Select Page Mode 154
1B 52 n
Select International Character Set 109
1B 53 Select Standard Mode 155
1B 54 n
Select Print Direction in Page Mode 156
1B 56 n Select or Cancel 90 Degrees Clockwise Rotated 110
1B 57 n1, n2,…n8
Set Printing Area in Page Mode 157
1B 59 n1 n2 d1…dn Select Double Density Graphics 119
1B 5B 7D Switch to Flash Download Mode 174
1B 5C n1 n2 Set Relative Print Position 95
1B 61 n Select Justification 96
1B 63 34 n Select Sensors to Stop Printing 83
1B 63 35 n Enable or Disable Panel Buttons 83
1B 64 n Print and Feed n Lines 91
1B 69 Perform Full Knife Cut 81
1B 6A k Read from Non-Volatile Memory 163
1B 6D Perform Partial Cut 81
1B 70 n p1 p2 Generate Pulse to Open Cash Drawer 84
1B 72 n
Select Print Color
110
1B 73 n1 n2 k Write to Non-Volatile Memory (NVRAM) 163
1B 74 n Select International Character Set 109
1B 75 0 Transmit Peripheral Device Status 127
1B 76 Transmit Paper Sensor Status 127
1B 7B n Select or Cancel Upside Down Printing Mode 110
1C 21 n Select print modes for Kanji characters 170
1C 2D n Turn underline mode ON/OFF for Kanji 171
1C 32 c1 c2 d1…dn Define user-defined Kanji characters 171