NCR 7454 - Page 113

Chapter 4: Operating System Recovery 4-3
3. Applypowe rtotheterminalsotheCD‐ROMdrivecanbeopened.
4. InserttheCDthatcontainstheoperatingsystemimage.
7454
Model Software CD LPINs
Win2000 WinXPe WinNT Win98 Win95 DOS
*22xx D370‐0489‐0100 NotSupported D370‐0433‐0100 D370‐0444‐0100 D370‐0442‐0100 D370‐0445‐0100
32xx D370‐0516‐0100 D370‐0565‐0100 D370‐0501‐0100 D370‐0500‐0100 D370‐0503‐0100
**Controlled
D370‐0445‐0100
34xx,
35xx,
36xx,
37xx
D370‐0516‐0100 D370‐0565‐0100 D370‐0501‐0100 D370‐0500‐0100 **Discontinued D370‐0445‐0100
Note: *The22xxmodelshavebeendiscontinued.ContactNCR
ProductManagerforLPINavailability.
**ContactProductManagerforControlledDeliverysupportof
Windows95LPINfor32xxmodel.
5. Boottheterminal.
6. Press
F2atthescreenprompttoenterSetup.
7. Press
F9tosetBIOSSystemdefaults.
8. Inthe
Advancedmenu,selectI/O Device Configuration.
9. Verifythatthe
LPT 1 ModeissettoECP.
10. Gobacktothe
Advancedmenu,selectMultiple ROM Menu.
11. Setthe
Parallel CD-ROM BoottoEnabled.
12. Setallother
BootoptionstoDisabled.