NCR 7454 - Page 114

4-4 Chapter 4: Operating System Recovery
13. ExitSetupandSaveChanges.
Astheterminalreboots,youshouldseeamessageduringboot
indicatingthattheCD‐ROMhasbeenrecognized:
Micro Solutions BACKPACK CD-ROM v0.3
. . .
Booting from BACKPACK CD
Starting MS-DOS
14. FollowtheDOSscreenprompts.Aftereachentryyouareaskedto
confirmyourinput.Youcanuse1oryforYes,2ornforNo.
15. Enterwhetherornotyouwanttoperform
Disk verification.
(AnsweringYestakestwiceaslong,butisrecommended.)
IfYesisselected:
• TheGhost
®
softwareverifieswriteoperationsandhandlesbad
FATclusters.
• TheGhosterrorfile(GH O ST.ERR) isdisplayedbefore
rebooting
IfNoisselected:
• TheGhosterrorfileisdisplayedbeforerebootingonlyifGhost
aborts.
Caution: Iftheerrorfileisdisplayed,thebatchfilepausesfor
userinputbefore
rebooting.YoumayuseCtrl‐Ctocanceloutof
thebatchfileifyouwanttoseetheerrorfileagain,butnothing

shouldbedonethatwritestotheharddiskbeforerebooting.
GHOST.ERRisontheRAMdiskandisloston reboot.