EasyOne Pro™ / EasyOne Pro™ LAB 39
Start-up and Initial Preparation
Note
EasyOne Pro™
is equipped with a touch screen display. You
activate a button by touching it on the display.
(h, Fig. 2-24) is used to display and remove the touch
keypad that allows you to make all entries.
Before the first test, you should follow the instructions given
in "System Settings" on page 110 and
enter the practice/office or hospital name
select the language
select the test types and parameters
Note
After each exchange of the gas cylinder, check whether the
gas concentration in the program corresponds to the
specifications on the cylinder
. Follow these steps:
Fig. 2-24 Initial Screen
a Selected patient
b Practice, office, hospital (see "General
Tab" on page 111 for details about
entering the data)
c Click to select a patient or add a new
patient
dClick to perform a test
e Click to review the results from previ-
ous tests
f Click to view the setup screen
g Sensor status (sensor icon, if sensor is
connected)
h Click to display the keypad
i Help button
j Click to quit the program
To Next Page
Loading...
Need help?
General
