Changing the Settings on your e228 -62-
Call time info.
Displays and sets the call time information.
Call options
Item Description
Current call time Allows you to change the call time display setting. Select Current call, Outgoing
calls, All calls or OFF.
Under the following items, the call time information is displayed in All calls,
Outgoing calls and Incoming calls.
Summary list Displays summary information for calls.
Voice calls Displays voice call information.
Video calls Displays video call information.
Reset call timer Resets the call time to zero.
Item Description
Receiver volume Sets the volume level for receiving calls.
Quality alarm Turns the quality alarm on/off. This notifies you that your call may be disconnected if
you move into an area where there is a weak signal. Select No alarm, Loud alarm
and Soft alarm.
Any key answer Turns the any key answer function on/off. This lets you use any key to answer a call,
except for the SK2 (Ignore), End (Reject call), Up and Down keys.
Dial pause setting Edits a string of keypad characters (up to 127 single-byte characters) for pause
dialling. This function enables sending out of numbers while calling with pauses
inserted.
For example, after entering a number with the touch tone service, you can send out
the numbers you entered beforehand.
Pause dial entry function is useful for sending messages to a pager, etc. You can
only use keypad characters (0-9, # and ) and pause (press and hold the # key:
displayed as p). A pause at the beginning cannot be registered. A pause at the end
is deleted when registered. Registered pause dial entry can only be used while
calling. Sent out pause dial entries are not saved in the Outgoing calls list.
To Next Page
Loading...
