Document Revision 1 Electra Elite IPK II
2 Installation
2 Installation
The process of installing PCPro is straight forward. Just run the installation program and
follow the instructions. To install PCPro, the following system requirements should exist.
When installing PCPro for the first time, the installation program will create a set of default
PCPro accounts. The accounts are:
An install/uninstall will not remove or modify any existing PCPro accounts, or Connection
accounts.
Table 1 System Requirements
CPU
Pentium III 598MHz (minimum)
Pentium 4 2.5GHz (recommended)
Memory
128 MB of RAM
256 MB (recommended)
OS
Microsoft Windows 2000 or higher
Other
Microsoft Internet Explorer 6.0
Communication port
LAN, RS232 or Modem
Disk Space
25MB for PCPro (minimum)
TCP Port
PCPro needs TCP port 8000 to be open between the KTS and the
host PC. Communications between PCPro and the KTS occurs on
this port when uploading / downloading via LAN.
TCP port 5963 is required to be open if the Debug Terminal is going
to be used.
Table 2 Default PCPro Accounts
User Name Password Access Level
necii 47544 Manufacturer Mode (MF)
tech 12345678 Installer Mode (IN)
ADMIN1 0000 System Administrator Mode 1 (SA)
ADMIN2 9999 System Administrator Mode 2 (SB)
To Next Page
Loading...
