Electra Elite IPK II Document Revision 1
Standard View 21
Trunk Group DID Settings
Details Trunk Group specific DID settings. These settings are linked with 22-09.
8.0 NIGHT MODE SWITCHING
This screen combines system data relevant to the KTS feature “Night Service”. To
setup up a Night Mode Service Group complete the following:
1. Enable/disable users from activating Night Mode Service via a service code.
2. Enable/disable Automatic Night Mode Service.
3. Specify a Night Mode Service Group to modify
4. Define Schedule Patterns used by the selected Night Mode Service Group.
Schedule Patterns are comprised of time frames which are associated to
Night Modes.
5. Specify the Service Patterns applied to each day of the week.
Figure 13 Standard View - Night Mode Switching
To Next Page
Loading...
