Document Revision 1 Electra Elite IPK II
30 Standard View
12.0 TRUNK GROUPS
This screen combines system data relevant to Trunk Groups. Trunk Groups
prioritize the use of a group of trunks. Priority of Trunk Groups can be done via the
Route Table. A Route Table entry can then be used by trunks and extensions.
To setup a Trunk group complete the following:
1. Specify a Trunk Group entry to modify.
2. Select which trunks are members of the Trunk Group.
3. Prioritize trunks by ordering them in preference.
To setup a Route Table entry, complete the following:
4. Define 4 destinations where the Route Table entry will direct calls to. Calls
can terminate on a Trunk Group or flow on to another entry in the route
table.
Figure 19 Standard View - Trunk Groups
To Next Page
Loading...
