Electra Elite IPK II Document Revision 1
Wizards 35
2.0 USING WIZARDS
To complete a Wizard do the following:
1. Select the Wizard from the Wizard View Menu.
2. Modify the desired settings on the screen.
3. Navigate to the next screen in the Wizard to modify.
4. Complete steps 2 and 3 till all screens are finished.
5. Apply changes.
When programming a Wizard, changes to system data are applied:
J
whenever the Apply button is pressed.
J
whenever the user moves to a different page in the Wizard.
J
whenever the user exits the Wizard except in the case when the Cancel button
is pressed.
The Cancel button will only discard changes made on the current screen. It will
not undo all changes made in the Wizard.
Figure 21 Wizard Programming
To Next Page
Loading...
