4. Setup for Solving Problems
Express5800/R320c-E4, R320c-M4, R320d-E4, R320d-M4 Installation Guide (Windows Server 2008)
5. Click Settings under Startup and Recovery.
6. Specify the folder to store the debug information in the Dump file: text box and click OK.
Example: To store the debug information in D drive under the file name MEMORY.DMP:
Note the following when specifying a dump file.
– For the Write debugging information drop-down list, we recommend specifying Complete
memory dump. If the mounted memory size is greater than 2 GB, however, Complete memory
dump cannot be specified because it is not displayed on the drop-down list. In this case, specify
Kernel memory dump instead.
– Specify a drive that has a free space of at least "the memory capacity mounted on the server + 300
MB".
– The size of the debug information (memory dump) to be collected changes if memory is added. Make
sure that the free space of the drive to store the debug information (memory dump) is sufficient. If you
attempt to add memory that will cause the mounted memory size to exceed 2 GB, specify Kernel
memory dump.
To Next Page
Loading...
Need help?
General