3.5
Installing ft Server Control Software
You must quit all programs including Microsoft management console.
1. Install ft Server Control Software in the following procedure.
When ft Server Control Software UPDATE media is not provided:
(1) After logging on to the system as a user with the Administrative account, insert the
EXPRESSBUILDER DVD into the optical disk drive of the server.
(2) On the menu screen, click Integrated Installation, select ft Server Control Software on the menu,
and then click Install.
When ft Server Control Software UPDATE media is provided:
Install ft Server Control Software from the UPDATE media according to Instruction Manual that comes
with the media.
Follow the instructions to proceed with the installation.
Note
The message "ft Server Control Software, Now Installing... Please Wait." is displayed
during installation.
Do not use the keyboard or mouse while this message is being displayed.
2. When installation starts, a message "If there is a disc in the DVD drive, please remove it." will be
displayed. If EXPRESSBUILDER DVD is set in optical disk drive, remove it.
3. The system is rebooted several times during the installation. After the system is rebooted, log in again as
the user logged in before rebooting.
4. Installation of the ft Server Control Software resumes after you logged on.
5. When the message "Installation is finished" is displayed, click OK to reboot the server.
Note
Change the screen to check the message by using the taskbar, as the message may hide
behind the screen.
To Next Page
Loading...
Need help?
General