NEC Express 5800/R320c-E4 - Setup with Windows Standard Installer

3. Setting Up Windows Server 2008 R2
Express5800/R320c-E4, R320c-M4, R320d-E4, R320d-M4 Installation Guide (Windows Server 2008)
47
Chapter 1 Installing OS
3.3 Setup with Windows Standard Installer
This section describes how to install Windows with Windows Standard Installer.
Important
• Setup with Windows standard Installer may erase all data in the hard disk drive
depending on the settings. Pay attention to input parameters.
Backing up user data, as needed, is recommended.
•
Although some dialog boxes and popup windows are displayed during installing
ft Server Control
Software in Setup, do not operate from the keyboard and the
mouse. Installation is continued automatically.
Do not operate especially although the following dialog is displayed. When
installation is stopped with operation of a keyboard or a mouse, there is a
possibility that OS does not start normally.
Tips
• Setup with Windows Standard Installer allows you to use a pre-specified parameter file
or save the parameters specified in setup as a parameter file on a removable media.
• For details on creating a parameter file, see Chapter 1 (5. Windows OS Parameter
File).