3. Setting Up Windows Server 2008 R2
Express5800/R320c-E4, R320c-M4, R320d-E4, R320d-M4 Installation Guide (Windows Server 2008)
3.11
Creating Volume
For NEC Express5800/ft series, you need to set mirroring for each disk by the RDR function. If you created a
new partition or volume on the disk that has been set RDR and dual configuration, the area is mirrored
automatically. You do not need to perform mirroring for each partition or volume.
Important
• Note the following issues when you execute Active Upgrade under the status
that the OS installed disk has partitions other than the system partition.
–
All the data upgrade is discarded for the system disk of the Production Side
that runs Active Upgrade.
• A mirrored volume (RAID-1) or RAID-
5 volume cannot be used on a dynamic
disk.
3.12
Installing Bundled Software for the Server
NEC ESMPRO Agent and NEC ESMPRO Manager are contained in EXPRESSBUILDER.
Make sure that the installed utilities are shown on Start - Programs or on Control Panel. If you did not install
these utilities during setup with EXPRESSBUILDER, install them individually by according to Chapter 2
(Installing Bundled Software).
To Next Page
Loading...
Need help?
General