NEC Express 5800/R320c-E4 - 5. Windows OS Parameter File

5. Windows OS Parameter File
Express5800/R320c-E4, R320c-M4, R320d-E4, R320d-M4 Installation Guide (Windows Server 2008)
107
Chapter 1 Installing OS
5. Windows OS Parameter File
This section describes a parameter file for Windows OS.
5.1 Creating Windows OS Parameter File
If a parameter file is used when performing Setup with EXPRESSBUILDER, the settings from the previous
installation can also be used when re-installing the system.
It is therefore recommended to use a parameter file to set up the server.
5.1.1
How to create a parameter file
Follow the procedure described below to create a parameter file.
Note
Do not remove EXPRESSBUILDER DVD from the drive while creating a parameter file.
Tips
Use Internet Explorer 7 or later version for creating a parameter file.
1. Start Windows OS.
2. Insert the supplied EXPRESSBUILDER DVD into the optical disk drive.
Run the program by using autorun feature of Windows.
3. Click Applications.