4. Setup for Solving Problems
Express5800/R320c-E4, R320c-M4, R320d-E4, R320d-M4 Installation Guide (Windows Server 2008)
11. In the Paging file size for each drive group box, specify as follows:
For the Initial size text box, specify a value equal to or greater than the Recommended value shown in
the Total paging file size for all drives area.
For the Maximum size text box, specify a value equal to or greater than the value specified in the Initial
size text box.
After specifying the above values, click Set.
Note the following when specifying a paging file size.
– The above paging file sizes are recommended for collecting debug information (dump file). The initial
size of the Windows partition paging file must be large enough to store dump files. Make sure to set a
sufficient paging file size. If the paging file size is insufficient, correct debug information might not be
able to be collected due to a shortage of virtual memory.
– For details about the Recommended value in the Total paging file size for all drives area, see System
partition size in Chapter 1 (Before Starting Setup).
– When memory is added, re-specify the paging file according to the increased memory size.
12. Click OK.
A message to restart the system might appear, depending on the modifications made.
In this case, restart the system.
Specification of the memory dump settings is now complete.
To Next Page
Loading...
