3. Setting Up Windows Server 2008 R2
Express5800/R320c-E4, R320c-M4, R320d-E4, R320d-M4 Installation Guide (Windows Server 2008)
5. Connect power cords to the server in the following order.
(1) Connect a power cord to AC inlet connector A.
(2) Connect a power cord to AC inlet connector B.
(3) Make sure the Status LED on CPU/IO module is unlit.
Note
If you disconnect the power cord, wait at least 30 seconds before connect it again.
AC inlet
connector A
REAR
AC inlet
connector B
To Next Page
Loading...
