5-8 I/O Board Installation
4. Carefully and slowly pull the PCIX unit out of the cabinet until the side rails
lock (click) in place.
!
CAUTION
Check that the cables at the rear of the cabinet are free from
being pinched or damaged when you slide the PCIX unit
forward.
5. Lift and swing the PCIX unit PCI slot access cover open (see Figure 5-5).
A Cover Handles
B PCIX Unit PCI Slot Cover
Figure 5-5 PCIX Unit PCI Slot Access Cover
6. Install the board in the appropriate slot.
Note: See the previous sections in this chapter to
select the correct slot for your board type. Correct slot
location can optimize board performance.
! Carefully remove the slot cover.
!
WARNING
Take care when removing the slot cover. System power is
on during this installation. Dropping a slot cover can create a
short circuit, causing personal injury and damage to the
system if the slot cover makes contact with a connector.
! Insert the board into the slot.
A
B
To Next Page
Loading...
