22
How to set up RAID with Intel Software RAID (RSTe)
1.
Power on system and press <F2> during POST.
2. Select Advanced→ SATA Configuration→SATA Mode, set this item to RAID Mode.
3. Save Changes and Exit.
Configuring a RAID array in RAID BIOS
Enter the RAID BIOS setup utility to configure a RAID array. Skip this step and proceed with the
installation of Windows operating system for a non-RAID configuration.
NOTE: POST screen runs fast. If you miss the message of <CTRL-I> during POST,
please press <Ctrl> + <I> key after about 10 seconds after powering on.
1. After the POST memory test begins and before the operating system boot begins.
Press <Ctrl-I> to enter Configuration Utility".
2. After you press <Ctrl> + <I>, the MAIN MENU screen will appears.
To Next Page
Loading...