44
Setting Up Your Projector
2-7-1. Make the option board usable
By registering the mounted option board to the slot, you can use option board by setting up the projector. This procedure is
described for the example, when IMB (NC-90MS01) is mounted to slot A. For the operation of the projector, refer to projector’s
“Users Manual”.
TIP
DCC for S2 can be used to set up.
For the procedure by using DCC for S2, refer to “Digital Cinema Communicator for S2 Installation Manual”.
Set the projector in standby mode.
Enable the service personnel menu.
These settings are for our service personnel and cannot normally (user mode) be used. You need to enter a passcode
to enable the service personnel menu. Refer to the “4-1-1. When You Use the Service Personnel Menu” (page 63) for
the procedure.
Press the MENU button on the control panel.
“Title Select” is displayed in the menu. From this procedure on, control panel of the projector will be used.
Press the LEFT/RIGHT button to display “Conguration” and press the DOWN button.
Press the LEFT/RIGHT button to display “Installation” and press the DOWN button.
Press the LEFT/RIGHT button to display “Option Slot” and press the DOWN button.
To Next Page
Loading...
Need help?
General
