NEC NC900C - 3 Projector Adjustment and Connecting; Flow of Adjustment and Connecting

46
3. Projector Adjustment and Connecting
3-1. Flow of Adjustment and Connecting
Adjustment and Connecting of the projector accord to the procedure below.
• Step1
Turning Your Projector On (See page 50)
• Step2
Setting The Date and Time in the Projector (See page 51)
• Step3
Setting the Projector Projection Method (See page 52)
• Step4
Adjusting the Lens (See page 54)
Display the test pattern to adjust the screen size, screen ratio and focus.
• Step5
Replacing the notch filter (See page 56)
• Step6
Connecting with the Image Input Port (See page 59)
• Step7
Connecting the Various Control Terminal (See page 60)
This chapter explains the adjustment and connection of the projector with Steps 1 to 7.
Steps 1 to 7 complete the adjustment and connection of the projector. Next, carry out various settings such as color adjustment
using DCC for S2. Refer to the “Digital Cinema Communicator for S2 Installation Manual” for the procedure.