NEC NC900C - Error Code List

82
Appendix
5-2. Error Code List
Please inquire your dealer/distributor about action to be taken for each error code.
Error Code Error message Description
4 GPSU(12V) Fail Power supply is abnormal.
5 Lamp Unlit Lamp doesn’t light up.
12 E2PROM R Fail E2PROM data read error is detected.
15 E2PROM W Fail E2PROM data write error is detected.
120 DLP Ack Fail ICP failed operation. It could be caused by configuration
files lost, disk space issue, or DISKCHIP corruption issue.
121 Lens Fail Lens unit control error
140 DLP CommR Fail No communication with the ICP board.
(Communication I/F is RS-232C)
141 DLP CommE Fail No communication with the ICP board and DCC.
(Communication I/F is Ethernet)
151 Fan1 Stop Fan1 has stopped.
152 Fan2 Stop Fan2 has stopped.
153 Fan3 Stop Fan3 has stopped.
154 Fan4 Stop Fan4 has stopped.
155 Fan5 Stop Fan5 has stopped.
156 Fan6 Stop Fan6 has stopped.
157 Fan7 Stop Fan7 has stopped.
158 Fan8 Stop Fan8 has stopped.
159 Fan9 Stop Fan9 has stopped.
164 ICP Fan Stop ICP Fan has stopped.
165 GPI MACRO(n) Selection Invalid Selection of preset button (n) through GPI is invalid
because metadata is enabled.
166 GPI Control Invalid Projector control through GPI is invalid because projector
is busy.
177 Tamper Fail Service door tamper switch of projector is open.
178 Marriage Tamper Fail Marriage tamper switch of projector is open.
180 CPU Fail(Mem) System Test Failed during lamp on. (Memory)
201 Error Log Write Fail Failed to write error log.
215 Filter Time Over The time to exchange filters.
The time to exchange filters.
220 AC On Fan Exchange Time The time to exchange fans.
230 Router Fail Failed to control router.
232 MAC Write Fail Failed to setup MAC address of CPU board.
235 Router Self Check Fail Router health-check error.
240 SIB Comm Fail Failed to communicate with SIB.
241 SIB Error SIB internal error.
242 SIB FPGA Reboot Executed to re-boot SIB FPGA for recovery.
245 Fan10 Stop Fan10 has stopped.
246 Fan11 Stop Fan11 has stopped.
247 Fan12 Stop Fan12 has stopped.
248 Fan13 Stop Fan13 has stopped.
249 Fan14 Stop Fan14 has stopped.
251 Fan1 Stop Precaution Fan1 Stop Precaution.
252 Fan2 Stop Precaution Fan2 Stop Precaution.
253 Fan3 Stop Precaution Fan3 Stop Precaution.
254 Fan4 Stop Precaution Fan4 Stop Precaution.
255 Fan5 Stop Precaution Fan5 Stop Precaution.
256 Fan6 Stop Precaution Fan6 Stop Precaution.
257 Fan7 Stop Precaution Fan7 Stop Precaution.