NEC NC900C - Page 83

83
Appendix
Error Code Error message Description
258 Fan8 Stop Precaution Fan8 Stop Precaution.
259 Fan9 Stop Precaution Fan9 Stop Precaution.
263 ICP Fan Stop Precaution ICP Fan Stop Precaution.
264 Fan10 Stop Precaution Fan10 Stop Precaution.
265 Fan11 Stop Precaution Fan11 Stop Precaution.
266 Fan12 Stop Precaution Fan12 Stop Precaution.
267 Fan13 Stop Precaution Fan13 Stop Precaution.
268 Fan14 Stop Precaution Fan14 Stop Precaution.
270 SD Tamper Terminate Terminated service door tamper event latched by Enigma
board.
* This message would be shown on Log, not on LCD.
271 IMB:SD Tamper Terminate Terminated service door tamper event latched by IMB.
* This message would be shown on Log, not on LCD.
301 System Error ICP system status error
302 Self Test Error ICP system status error
To recover the issue, update ICP to higher than Prod3.0 or
equal. If that can not remove the issue, remove and reseat
the ICP board.
303 Install Release Package Error ICP system status error
It could be caused by disk space issue or DISKCHIP
corruption issue.
304 Load Release Package Error ICP system status error
It could be caused by disk space issue or DISKCHIP
corruption issue.
305 Key Error ICP system status error
306 Certificate Error ICP system status error
317 ICP Normal Configuration Error ICP system status error
318 ICP Boot Configuration Error ICP system status error
319 FMT Normal Configuration Error ICP system status error
320 FMT Boot Configuration Error ICP system status error
321 FMT Satellite Configuration Error ICP system status error
322 1.20V Supply out of range ICP system status error
323 1.80V Supply out of range ICP system status error
324 2.50V Supply out of range ICP system status error
325 3.30V Regulator out of range ICP system status error
326 ICP FPGA Temperature out of range ICP system status error
327 FMT FPGA Temperature out of range ICP system status error
328 ICP Flash Update Error ICP system status error
329 FMT Sequence Data File Mismatch ICP system status error
330 FMT DMD Data File Mismatch ICP system status error
331 FMT Flash Checksum Error - Sequence Data ICP system status error
332 FMT Flash Checksum Error - DMD Data ICP system status error
333 Satellite Hardware Mismatch ICP system status error
334 FMT Flash Update Error ICP system status error
335 Red Satellite Reports Reset ICP system status error
336 Red Satellite Serial Link Error ICP system status error
337 Red Satellite Firmware Configuration Error ICP system status error
338 Red DAD1000 Bias Under Voltage Error ICP system status error
339 Red DAD1000 Reset Under Voltage Error ICP system status error
340 Red DAD1000 Offset Under Voltage Error ICP system status error
341 Red DAD1000 Thermal Shutdown Error ICP system status error
342 Green Satellite Reports Reset ICP system status error
343 Green Satellite Serial Link Error ICP system status error
344 Green Satellite Firmware Configuration Error ICP system status error
345 Green DAD1000 Bias Under Voltage Error ICP system status error