48
Projector Adjustment and Connecting
3-2-1. Procedure for Recovering from Tamper Errors
If a tamper error is displayed when the projector power is turned on, recover by using the following procedure.
Start recovery
Recovery complete
Is “Physical Marriage Tamper” or
“Marriage NOT Active” displayed?
Is “Tamper Fail” or “Marriage Tamper
Fail” displayed?
Is “Service Door Tamper” displayed?
Step 3
Perform re-marriage using the Digital Cinema
Communicator for S2
Step 2
Log in to the projector with Advanced User or higher
privileges using the buttons on the control panel.
Yes
No
Yes
No
Yes
No
Step 1
- Attach the front cover and side cover
- Check that the equipment is correctly attached to slot
To Next Page
Loading...
