NEC NC900C - Page 86

86
Appendix
Error Code Error message Description
753 OverTemp.Ballast1 Precaution Set inside temperature (Ballast1) is close to over
temperature.
754 OverTemp.Ballast2 Precaution Set inside temperature (Ballast2) is close to over
temperature.
760 OverTemp.DMD Set inside temperature (DMD) is abnormal.
761 OverTemp.Inlet Set inside temperature (Inlet) is abnormal.
762 OverTemp.Lamp Set inside temperature (Lamp) is abnormal.
764 OverTemp.Ballast1 Set inside temperature (Ballast1) is abnormal.
765 OverTemp.Ballast2 Set inside temperature (Ballast2) is abnormal.
781 Interlock Open Interlock is open.
782 SystemI2cFail Failed to control sensors connecting to GPIO chip.
(Slave board internal abnormality)
783 EepromFail Slave MCU failed to read back all of data from EEPROM
on slave MCU board due to unexpected data or
something.
(Slave board internal abnormality)
785 SoftwareI2cFail I2C/UART conversion chip control failed on slave board.
(Slave board internal abnormality)
786 PreCooling Failed to precool.
787 Lamp Door1 Open Lamp1 door (cover) is open.
788 Lamp Door2 Open Lamp2 door (cover) is open.
789 Ballast1UartError Communication error between slave MCU and ballast1.
790 Ballast2UartError Communication error between slave MCU and ballast2.
791 FanInitError Failed to initialize fans.
792 ExGpioFail Failed to control the signal connecting to Ballast.
(Slave board internal abnormality)
793 Notch Filter Open Notch Filter Cover is open.
800 Fan15 Stop Fan15 has stopped.
801 Fan16 Stop Fan16 has stopped.
810 Fan15 Stop Precaution Fan15 Stop Precaution
811 Fan16 Stop Precaution Fan16 Stop Precaution