NEC NC900C - Page 85

85
Appendix
Error Code Error message Description
464 SelfTest HMAC Algorithm Integrity Error Enigma is in FIPS error state. (Self test result)
465 SelfTest SHA Algorithm Integrity Error Enigma is in FIPS error state. (Self test result)
466 SelfTest TLS Integrity Error Enigma is in FIPS error state. (Self test result)
467 SelfTest FPGA Configuration Integrity Error Enigma is in FIPS error state. (Self test result)
468 SelfTest FPGA CineLink. 2 Decryption Integrity Error Enigma is in FIPS error state. (Self test result)
474 Security Tamper Security tamper condition exists in Enigma.
475 Top Side Security Enclosure Open Security tamper condition exists in Enigma.
476 Bottom Side Security Enclosure Open Security tamper condition exists in Enigma.
477 Security Battery Event Battery tamper condition exists in Enigma.
478 Software Commanded Zeroization Destroyed Enigma key by software command.
481 Security Enclosure Not Armed Enigma security not armed.
482 Physical Marriage Tamper Latched physical marriage tamper condition on Enigma
board.
483 Logical Marriage Tamper Logical marriage tamper condition exists in Enigma.
484 Marriage NOT Active Marriage between ICP and Enigma has NOT been
established (active).
486 Service Door Tamper Latched service door tamper condition on Enigma board.
487 Security Log Error Security log is full and no more log entries can be created
in Enigma. It is the server’s responsibility to avoid the
issue.
488 Security Battery Low Warning Close to “(477) Security Battery Event”.
489 Security Log Warning Security log is almost full in Enigma.
Close to “(487) Security Log Error”.
500 IMB Comm Fail No communication with the IMB.
510 IMB:System Error IMB Status error
511 IMB:Self Test Error IMB Status error
519 IMB:Certificate or Key Error IMB Status error
520 IMB:ICP Communications Status IMB fails to do logical marriage to ICP when IMB powers
up. Because of no communications with ICP during logical
marriage.
537 IMB:RTC Error IMB RTC is “invalid”.
543 IMB:FPGA Temperature out of range IMB Status error
550 IMB:Supply voltage out of range IMB Status error
574 IMB:Security Tamper Security tamper condition exists in IMB.
577 IMB:Security Battery Event Battery tamper condition exists in IMB.
581 IMB:Security Enclosure Not Armed IMB security not armed.
582 IMB:Physical Marriage Tamper Latched physical marriage tamper condition on IMB.
583 IMB:Logical Marriage Tamper Logical marriage tamper condition exists in IMB.
584 IMB:Marriage NOT Active Marriage between ICP and IMB has NOT been
established (active).
586 IMB:Service Door Tamper Latched service door tamper condition on IMB
588 IMB:Security Battery Low Warning Close to “(577) IMB: Security Battery Event”.
700 Slave Comm Fail Failed to communicate with slave MCU.
701 Slave Status Fail Slave MCU is in unexpected status.
702 Lamp Lit Change Lamp lit status becomes with unexpected state.
(It could appear while dual lamp mode.)
703 Slave Comm Ack Fail Slave fails to execute the command.
710 Lamp1 OverTime Lamp1 cumulative time is over.
711 Lamp2 OverTime Lamp2 cumulative time is over.
740 SensorFail Inlet Failed to read inlet sensor.
741 SensorFail DMD Failed to read DMD sensor.
750 OverTemp.DMD Precaution Set inside temperature (DMD) is close to over
temperature.
751 OverTemp.Inlet Precaution Set inside temperature (Inlet) is close to over temperature.
752 Down Lamp Power Activated Down lamp power to decrease set inside temperature.