NEC PX1004UL-WH - Page 106

89
5. Using On-Screen Menu
Using the Entry List
Whenanysourceadjustmentsaremade,theadjustmentsareautomaticallyregisteredintheEntryList.The(adjust-
mentvaluesof)registeredsignalscanbeloadedfromtheEntryListwhenevernecessary.
Upto100patternscanberegisteredintheEntryList.When100patternshavebeenregisteredintheEntryList,an
errormessageisthendisplayedandnoadditionalpatternscanberegistered.Youshouldthusdelete(adjustment
valuesof)signalsthatarenolongerneeded.
Displaying the Entry list
1. Press the MENU button.
 Themenuwillbedisplayed.
2. Press the ◀ or ▶buttontoselect[INPUT].
 TheINPUTlistwillbedisplayed.
3. Use the ◀, ▶, ▲, or ▼toselect[ENTRYLIST]andpresstheENTERbutton.
 TheENTRYLISTwindowswillbedisplayed.
 IftheENTRYLISTwindowisnotdisplayed,switchthemenuto[ADVANCED].
 Toswitchthemenubetween[ADVANCED]and[BASIC],select[SETUP]→[CONTROL]→[TOOLS]→[AD-
MINISTRATORMODE]→[MENUMODE].(→page121)