NEC PX1004UL-WH - Performing Lens Calibration

18
2. Projecting an Image (Basic Operation)
3. Press the (POWER) button on the projector cabinet
or the POWER ON button on the remote control.
 ThePOWERindicatorgoesfromasteadyredlighttoa
ashing blue light, and the picture is projected on the
screen.
TIP:
• Whenthemessage“PROJECTORISLOCKED!ENTERYOUR
PASSWORD.” is displayed, it means that the [SECURITY]
featureisturnedon.(→ page 45)
 Afteryouturnonyourprojector,ensurethatthecomputer
orvideosourceisturnedon.
NOTE:Thebluescreen([BLUE]background)isdisplayedwhenno
signalisbeinginput(byfactorydefaultmenusettings).
Standby Blinking Power On
Steady red light
Blinking blue
light
Steady blue
light
(→page178)
Performing Lens Calibration
Afterinstallationorreplacementofthelens,besuretoperform
[LENSCALIBRATION]bypressingandholdingtheSHUT-
TER/CALIBRATIONbuttonontheprojectorcabinetforatleast
twosecondsorbyholdingtheCTLbuttonandpressingthe
INFO/L-CALIB.buttonontheremotecontrol.Perform[LENS
CALIBRATION]alsowhentroubleisfoundonthelensshift
motion.Calibrationcorrectstheadjustablezoom,shift,and
focusrange.Ifcalibrationisnotperformed,youmaynotbe
abletogetthebestfocusandzoomevenifyouadjustthe
focusandzoomforthelens.WhileperformingLensCalibra-
tion,theSTATUSindicatorashesingreentwicepercycle.
• Thefollowinglensesneedcalibration:
 NP16FL,NP17ZL,NP18ZL,NP19ZL,NP20ZL,NP21ZL,
NP31ZL