NEC PX1004UL-WH - Focus

26
2. Projecting an Image (Basic Operation)
Focus
Applicable lens unit: NP16FL/NP17ZL/NP18ZL/NP19ZL/NP20ZL/NP21ZL
1. PresstheFOCUS+/−buttonuntilyoucanobtainthebestfocus.
 (TheFOCUSadjustmentbarwillbedisplayedon.)
• Ontheremotecontrol,whilepressingontheCTLbutton,pressonVOL/FOCUS(+)or(−)button.
• ◀or▶buttonsonthecabinetortheremotecontrolarealsoavailabletoadjustFOCUSwhiletheFOCUS
adjustmentbarisdisplayedon.
TIP:
Toobtainthebestfocus,performthefollowing(forpermanentinstallation)
Preparation:Warmuptheprojectorforonehour.
1. UsetheFOCUS+/−buttonstomakesureyouobtainthebestfocus.Ifyoudonot,movetheprojectorback
andforth.
2. Selectthe[TESTPATTERN]fromthemenuanddisplaythetestpattern.(→ page 88)
• YoucanalsousetheTESTbuttonontheremotecontroltodisplaythetestpattern.
3. KeeppressingtheFOCUS−buttonuntilthegridofthetextpatternismadeinvisible.
• TheFOCUSadjustmentbardisplayingpositioncanbeshiftedorbeturnedofftemporarily.(→page36,37)
4. KeeppressingtheFOCUS+buttonuntilyouobtainthebestfocus.
Ifyouadjustbeyondthebestfocalpoint,gobacktostep3andrepeattheprocedures.