NEC PX1004UL-WH - ❼ Turning off the Projector

34
2. Projecting an Image (Basic Operation)
❼ Turning off the Projector
1. Press the (POWER) button on the projector cabinet
or the POWER OFF button on the remote control.
 The[POWEROFF/AREYOUSURE?/CARBONSAV-
INGS-SESSION0.000[g-CO2]]messagewillappear.
2. Press one among the ENTER, the (POWER), and the
POWER OFF button.
 Whentheprojector is inSTANDBYMODE,thePOWER
indicator lights up red. (When [STANDBY MODE] is in
[NORMAL]setting)
• Ifyoudonotwanttoturnoff,select[NO]by◀/▶button
andpressENTER.
3. Make sure the projector is in STANDBY MODE, then turn
offthemainpowerswitch(○ OFF)
 ThePOWERindicatorwillgooffandthemainpowerwill
turnoff.
• While the POWER indicator is blinking blue in short
cycles,thepowercannotbeturnedoff.
Power On
Steady blue light
Standby
Steady red light
CAUTION:
PartsoftheprojectormaytemporarilyoverheatiftheprojectoristurnedoffwiththemainpowerswitchortheAC
powersupplyisdisconnectedwhiletheprojectorisinoperationorthecoolingfanisrunning.Handlewithcare.