NEC PX1004UL-WH - Rear

7
1. Introduction
Rear
ACINterminal
Connectthesupplied
powercord’sthree-pin
plughere,andplugthe
otherendintoanactive
walloutlet.(→page14)
Theftpreventionscrew
holeforthelensunit
Mainpowerswitch
WhileACpowerisbeingsupplied,setthe
mainpowerswitchtoONposition(|),then
yourprojectorwillenterastandbystate.
PowerCordStopper
(→page16)
* ThissecurityslotsupportstheMicroSaver
®
SecuritySystem.
Built-inSecuritySlot( )*
SecurityBar
Fixingatheftprevention
device.
Thesecuritybaraccepts
securitywiresorchains
upto0.18inch/4.6mmin
diameter.
Handle(locatedon4posi-
tions)
Fortransportation
NOTE:
• For moving the projector,
makesureyouhaveatleast
two people. At the same
time, do not grip and hold
the projector other than by
these handles. Attempting
tomovetheprojectoralone
could result in back pain or
other injuries.
Intakevent
Takesinairtocooltheunit.
(→pagexi,155)
Terminals
(→
page9)
Exhaustvent
Heatedaiirisexhausted
fromhere.
(→pagexi,155)
Controls
(→
page8)