NEC PX1004UL-WH - ❸ Turning on the Projector

17
2. Projecting an Image (Basic Operation)
❸ Turning on the Projector
NOTE:
• Theprojectorhastwopowerswitches:AmainpowerswitchandaPOWERbutton(POWERONandOFFontheremotecontrol)
•Turningontheprojector:
1. Press the main power switch to the ON position (I).
 Theprojectorwillgointostandbymode.
2. Press the POWER button .
 Theprojectorwillbecomereadytouse.
•Turningofftheprojector:
1. Press the POWER button.
 Theconrmationmessagewillbedisplayed.
2. Press the POWER button again.
 Theprojectorwillgointostandbymode.
3. Press the main power switch to the OFF position (O).
 Theprojectorwillbeturnedoff.
1. Removethelenscapfromthelensunit.
2. Press the main power switch to the ON position ( I ).
 ThePOWERindicatorlightsupred.*
* ThisindicatesthattheSTANDBYmodeisin[NORMAL]
setting.
(→page136,178)
WARNING
The projector produces a strong light. When turning on
thepower,makesure no one within projectionrangeis
lookingatthelens.
NOTE:
• The[STANDBYMODE]settingwillbedisabledandtheprojector
willgointothesleepmodewhenthenetworkserviceisutilizedor
theprojectorreceivesHDBaseTsignal.Inthesleepmode,thefans
in the projector rotate for the purpose of interior parts protection.
Pleaserefertopage136 about the sleep mode.