NEC PX1004UL-WH - ❷ Connecting Your Computer;Connecting the Power Cord

14
2. Projecting an Image (Basic Operation)
❷ Connecting Your Computer/Connecting the Power Cord
1. Connectyourcomputertotheprojector.
 Thissectionwillshowyouabasicconnectiontoacomputer.Forinformationaboutotherconnections,see“(2)
MakingConnections”onpage145.
 Connectthedisplayoutputterminal(miniD-sub15pin)onthecomputertotheCOMPUTERINterminalonthe
projectorwithacommercially-availablecomputercable(withferritecore)andthenturntheknobsoftheterminals
tosecurethem.
2. Connectthesuppliedpowercordtotheprojector.
WARNING
MAKESURETOTAKETHEGROUNDCONNECTIONFORTHEDEVICE.
TOPREVENTFIREORSHOCK,DONOTEXPOSETHISUNITTORAINORMOISTURE.
DO NOT USE THIS UNIT'S PLUG WITH AN EXTENSION CORD OR IN AN OUTLET UNLESS ALL THE
PRONGSCANBEFULLYINSERTED.
 ImportantInformation:
• Whenplugginginorunpluggingthesuppliedpowercord,makesurethatthemainpowerswitchispushed
totheoff[O]position.Failuretodosomaycausedamagetotheprojector.
• Donotuseathree-phasepowersupply.Doingsomaycauseofmalfunction.
 Firstconnectthesuppliedpowercord’sthree-pinplugtotheACINterminaloftheprojector,andthenconnect
theotherplugofthesuppliedpowercordinthewalloutlet.
COMPUTER IN
Makesurethattheprongsarefullyinsertedinto
boththeACINterminalandthewalloutlet.
Towalloutlet
Computercable(withferritecore)
(soldcommercially)