NEC PX1004UL-WH - ❻ Optimizing Computer Signal Automatically; Adjusting the Image Using Auto Adjust

33
2. Projecting an Image (Basic Operation)
❻ Optimizing Computer Signal Automatically
Adjusting the Image Using Auto Adjust
WhenanimagefromHDMIIN,DisplayPortIN,BNCINterminal(analogRGB),COMPUTERIN,orHDBaseTisbeing
projected,andtheedgeiscutoffortheimagequalityispoor,thisbuttoncanbeusedtoautomaticallyoptimizethe
projectionimageonthescreen.
PresstheAUTOADJ.buttontooptimizeacomputerimageautomatically.
[Poorpicture] [Adjustedpicture]
NOTE:
Somesignalsmaytaketimetodisplayormaynotbedisplayedcorrectly.
• IftheAutoAdjustoperationcannotoptimizethecomputersignal,trytoadjust[HORIZONTAL],[VERTICAL],[CLOCK],and[PHASE]
manually.(→ page 96, 97)
• Ifyoucannotobtainanoptimizedpicture,referpage182.